Asus H87-PRO User Manual page 36

8. ATX power connectors (24-pin EATXPWR; 8-pin EATX12V)
These connectors are for ATX power supply plugs. The power supply plugs are
designed to fit these connectors in only one orientation. Find the proper orientation and
push down firmly until the connectors completely fit.
H87-PRO
H87-PRO EATX power connectors
•
•
•
•
•
1-22
EATX12V
GND +12V DC
GND +12V DC
GND +12V DC
GND +12V DC
PIN 1
For a fully configured system, we recommend that you use a power supply unit
(PSU) that complies with ATX 12V Specification 2.0 (or later version) and provides a
minimum power of 350W.
Do not forget to connect the 4-pin/8-pin EATX 12V power plug. Otherwise, the system
will not boot.
We recommend that you use a PSU with a higher power output when configuring a
system with more power-consuming devices. The system may become unstable or
may not boot up if the power is inadequate.
If you want to use two high-end PCI Express x16 cards, use a PSU with 1000W power
or above to ensure the system stability.
If you are uncertain about the minimum power supply requirement for your system,
refer to the Recommended Power Supply Wattage Calculator at http://support.asus.
com/PowerSupplyCalculator/PSCalculator.aspx?SLanguage=en-us for details.
EATXPWR
+3 Volts GND
+12 Volts +5 Volts
+12 Volts +5 Volts
+5V Standby +5 Volts
Power OK -5 Volts
GND GND
+5 Volts GND
GND GND
+5 Volts PSON#
GND GND
+3 Volts -12 Volts
+3 Volts +3 Volts
PIN 1
Chapter 1: Product introduction