Table of Contents
Advertisement
1
release tab
2
card retention latch
3
card
5. If you are removing the card permanently, install a filler bracket in the empty card-slot opening.
If you need a filler bracket,
contact
NOTE:
Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of the computer. The brackets also keep dust
and dirt out of your computer.
6. Snap the card retention latch into place.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
7.
Replace the computer
cover.
8. Uninstall the card's driver. See the documentation that came with the card for instructions.
9. If you removed a sound card:
a.
Enter system
setup, select Audio Controller, and change the setting to On.
b. Connect external audio devices to the audio connectors on the computer back panel.
10. If you removed a network adapter card:
a.
Enter system
setup, select Network Controller, and change the setting to On.
b. Connect the network cable to the integrated network connector on the back panel of the computer.
Installing a PCI Card in the Riser-Card Cage
1. Follow the procedures in
"Before You
2. If applicable, remove the card installed in the PCI3 connector on the system board.
3. Remove the riser-card cage:
a. Check any cables connected to cards through the back-panel openings. Disconnect any cables that will not reach the riser-card cage once they
are removed from the computer.
b. Gently pull on the handle and lift the riser-card cage up and away from the computer.
4
card-edge connector
5
card connector
Dell.
Begin."
Advertisement
Table of Contents
