Dell OptiPlex 3011 AIO Owner's Manual page 46

Option
Deep Sleep Control
Fan Control Override
USB Wake Support
Wake on LAN / WLAN
Block Sleep
Intel Smart Connect
Technology
Table 8. POST Behavior
Option
Adapter Warnings
Numlock LED
46
Description
NOTE: This feature does not work if you turn off your computer using the switch
on a power strip or surge protector or if Auto Power is set to disabled.
Allows you to define the controls when Deep Sleep is enabled.
• Disabled
• Enabled in S5 only
• Enabled in S4 and S5
Enabled in S4 and S5 is enabled by default.
Controls the speed of the system fan. This option is disabled by default.
NOTE: When enabled, the fan runs at full speed.
This option allows you to enable USB devices to wake the computer from standby.
• Enable USB Wake Support - This option is enabled by default.
This option allows the computer to power up from the off state when triggered by a
special LAN signal. Wake-up from the Standby state is unaffected by this setting and
must be enabled in the operating system. This feature only works when the computer
is connected to AC power supply. The options differ based on the form factor.
• Disabled - Does not allow the system to power on by special LAN signals
when it receives a wake-up signal from the LAN or wireless LAN.
• LAN Only - Allows the system to be powered on by special LAN signals.
• WLAN Only - Allows the system to be powered on by special WLAN signals.
(For Ultra Small Form Factor only)
• LAN or WLAN - Allows the system to be powered on by special LAN or WLAN
signals. (For Ultra Small Form Factor only)
• LAN with PXE Boot - Allows the system to be powered on by special LAN
signals.
This option is Disabled by default.
This option lets you block entering to sleep (S3 state) in operating system
environment.
• Block Sleep (S3 state) - This option is disabled by default.
This option is disabled by default. If this option is enabled, the feature will periodically
sense the nearby wireless connection while the system is asleep. The Smart Connect
will synchronize the email or social media applications that are open, when the
computer enters the sleep state.
Description
This option allows you to choose whether the system should display warning
messages when a certain power adapter is used. This option is enabled by default.
Specifies if the NumLock function can be enabled when the system boots. This option
is enabled by default.