Dell OptiPlex 3011 AIO Owner's Manual page 41

Option
Advanced Boot Options
Date/Time
Table 3. System Configuration
Option
Integrated NIC
Serial Port
SATA Operation
Drives
Description
• Exit - Exits and starts the computer.
The Enable Legacy Option ROMs option will allow the legacy option ROMs to load,
when in UEFI boot mode. Without this option, only UEFI option ROMs will load. This
option is required for Legacy boot mode. This Legacy boot mode is not allowed when
you enable the Secure Boot. By default, the Enable Legacy Option ROMs check-box is
not selected. The other options are:
• Load Defaults - Restores the default settings of the computer.
• Apply - Enables you to apply the settings.
• Exit - Exits and starts the computer.
Allows you to set the date and time. The changes to the system date and time takes
effect immediately.
Description
Allows you to enable or disable the integrated network card. You can set the
integrated NIC to:
• Disabled
• Enabled
• Enabled w/PXE (This option is selected by default)
• Enabled w/ImageServer
• Enable UEFI Network Stack
NOTE: Depending on the computer and its installed devices, the items listed in
this section may or may not appear.
Allows you to define the serial port settings. You can set the serial port to:
• Disabled
• COM1 (This option is selected by default)
• COM2
• COM3
• COM4
NOTE: The operating system may allocate resources even though the setting is
disabled.
Allows you to configure the operating mode of the integrated SATA hard drive
controller.
• Disabled - The SATA controllers are hidden.
• ATA - SATA is configured for ATA mode.
• AHCI - SATA is configured for AHCI mode. This option is enabled by default.
Allows you to enable or disable the various on-board drives:
• SATA-0
• SATA-1
41