Power Management Modes; Pin Assignments; Vga Connector - Dell 2405FPW - UltraSharp - 24" LCD Monitor User Manual

Humidity:
Operating
Nonoperating
Altitude:
Operating
Nonoperating
Thermal dissipation

Power Management Modes

If you have VESA's DPMS compliance display card or software installed in your PC, the monitor can automatically reduce its power consumption when not in
use. This is referred to as 'Power Save Mode'*. If input from keyboard, mouse or other input devices is detected by the computer, the monitor will
automatically "wake up". The following table shows the power consumption and signaling of this automatic power saving feature:
VESA Modes Horizontal Sync
Normal Active
operation
Active-off mode Inactive
Switch off -
NOTE: The OSD will only function in the 'normal operation' mode. Otherwise one of the following messages will appear
depending upon the selected input.
1: D-SUB
In Power Save Mode
Press computer power button
or any key on keyboard or move mouse
Activate the computer and wake up the monitor to gain access to the OSD.

Pin Assignments

VGA Connector

Pin Number 15-pin Side of the Connected Signal Cable
1 Video-Red
2 Video-Green
3 Video-Blue
4 GND
5 Self-test
6 GND-R
7 GND-G
8 GND-B
Computer 5V/3.3V
9
10 GND-sync
11 GND
Vertical Sync Video
Active Active
Inactive Blanked
- -
or
10% to 80% (noncondensing)
Storage: 5% to 90% (noncondensing)
Shipping: 5% to 90%(noncondensing)
3,657.6 m (12,000 ft) max
12,192 m (40,000 ft) max
272.8 BTU/hour (maximum)
201.2 BTU/hour (typical)
Power Indicator
Green 80 W (maximum)*
59 W (normal)**
Amber Less than 2 W
Off Less than 1 W
2: DVI-D
In Power Save Mode
Press computer power button
or any key on keyboard or move mouse
Power Consumption
* With Audio + USB
** Without Audio + USB