Automatic Save; Reset Functions - Dell 2405FPW - UltraSharp - 24" LCD Monitor User Manual

Automatic Save

With the OSD on, if you make an adjustment and then either proceed to another menu, or exit the OSD, the monitor automatically saves any adjustments you have made. If you make an adjustment and then wait for
the OSD to disappear the adjustment will also be saved.

Reset Functions

Factory Preset Restoration
NOTE: There is no "Undo" when you use the Reset function. To return to the previous function settings, you must adjust the functions again. Reset will set the clock and phase back to factory settings,
activating "auto adjust" may be required and this will optimize the image for your system.
OSD Warning Messages
A warning message may appear on the screen indicating that the monitor is out of sync.
Cannot Display this Mode
This means that the monitor cannot synchronize with the signal that it is receiving from the computer. Either the signal is too high or too low for the monitor to use. See
Vertical frequency ranges addressable by this monitor. Recommended mode is 1920 X 1200 @ 60Hz.
When monitor get into Power Save mode, one of the following messages will appear depending upon the selected input.
NOTE: The floating 'Dell™ ~ self-test Feature Check' dialog will appear on-screen if the monitor cannot sense a video signal.
Depending upon the selected input, one of the dialogs shown below appear.
available. (Please Move UP)
Exit leaves this submenu without resetting any values.
Position Settings resets the settings only for horizontal/vertical
Color Settings resets the Red, Green and Blue
setting of Normal Preset.
All Settings returns your monitor settings to those that were set at the time of manufacture. This includes color, position,
clock frequency, phase, brightness, contrast and OSD hold time.
1: D-SUB
In power save mode
Press computer power button
or any key on keyboard or move mouse
Activate the computer and wake up the monitor to gain access to the
Color Control
2: DVI-D
In power save mode
or
Press computer power button
or any key on keyboard or move mouse
OSD
Position.
settings to their original factory settings and sets to the default
Monitor Specifications for the Horizontal and