If it finds a cable connection with the computer, then it looks for activated VGA/DVI-D port on the computer and makes the
selection for that port.
NOTE:
screen will be turned off, when any button except power button is pressed. The monitor displays "No Input Signal" for the
corresponding connection .
B
Use this button to activate PIP (Picture-in-Picture)/PBP (Picture-by-Picture) mode adjustment.
Pressing this button continually will cycle the sub-screen through the PIP -> PBP -> OFF (Original state without sub-screen) modes
with the corresponding brief OSD menu.
PIP/PBP Select
PIP Settings:
Pressing PIP/PBP
The details of the menu is as follows:
- PIP Source : To select an input signal for PIP. (VGA/DVI/S-video/Composite/Component)
Use
and
- Swap : To switch the main-screen and sub-screen in PIP mode.
Use
and
If S-video/Composite video /Component video (Y Pb Pr) cable is not connected or the video source is turned off, the
for the first time in sequence (PIP) will open "PIP Setting" Menu.
to choose and
to select.
to choose and
to select.
or