Table of Contents
Advertisement
Appendix
Optional DIMM Installation
DIMM Installation
1
Turn the DTX900 power off, and discon-
nect the power cord.
2
Turn over the DTX900 so you can have
direct access to the underside.
To protect the data dial and sliders from damage, place the
DTX900 so the four corners are supported by something that
provides sufficient support, such as magazines or cushions.
Place supports at all four corners, taking care not to touch the
Data dial and Sliders.
Bottom surface of the
DTX900
3
Remove the slot cover.
Remove the screws from the slot cover by using a Phillips
screwdriver.
Slot cover
Underside of the DTX900
IMPORTANT
Keep the removed screws in a safe place. They will
be used when re-attaching the cover to the instru-
ment after installing the DIMMs.
148
DTX900 Owner's Manual
4
Insert the two DIMMs into the DIMM sock-
ets.
Location for DIMM installation
Installing the DIMM modules to the sockets
Rear panel
4-1 Press the ejector levers to the outside of the
4-2 Insert the DIMM vertically in the socket.
DIMM slot x 2
Make sure that the DIMM module is aligned
correctly before you install it.
Notch for alignment
Ejector lever
socket.
Press the DIMM in firmly until it "snaps" or
locks in place.
Confirm whether or not both the levers are
firmly locked.
Advertisement
Table of Contents
