HP Pavilion TouchSmart 14-b100 Maintenance And Service Manual page 89

IMPORTANT: Make special note of each screw and screw lock size and location during removal
and replacement.
Before removing the display assembly, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the display panel (see
6. Remove the keyboard (see
7. Remove the top cover (see
8. Remove the hard drive (see
9. Remove the USB board (see
10. Remove the WLAN (see
11. Remove the system board (see
12. Remove the display assembly (see
Remove the display assembly subcomponents:
1. If it is necessary to replace the webcam/microphone module:
a. Detach and release the webcam/microphone module as far as the webcam/microphone
module cable allows. (The webcam/microphone module is attached to the back cover with
double-sided tape.)
b. Disconnect the webcam/microphone cable (1) from the webcam/microphone module.
c. Remove the webcam/microphone module (2).
Battery on page 42).
Display panel on page
Keyboard on page 46).
Top cover on page 50).
Hard drive on page
USB board/audio jack on page
WLAN module on page
System board on page
Display assembly on page 78
44).
54).
57).
58).
61).
Component replacement procedures 81