Standard Usb Port Disabled - Dell W5300 Workgroup Laser Printer User Manual

4<x>
Unsupported
Firmware Card
54 Network <x>
Software Error
54 Std Network
Software Error
55 Unsupported
Flash
in Slot X
55 Unsupported
Option in Slot X
56 USB Port <x>
Disabled
56 Standard USB
Port Disabled
58 Too Many
Trays Attached
The printer detects an
unsupported version of firmware
on the installed firmware card
during the power-on cycle.
The printer cannot establish
communications with an installed
network port.
The printer detects an
unsupported flash memory card in
one of the connectors.
The printer detects an
unsupported option card in one of
the connectors.
Data has been sent to the printer
through a USB port, but the USB
port is disabled.
Too many drawers with matching
trays are installed on the printer.
You have installed an
Setup Menu.
Install additional printer
memory.
See also: Setup Menu
Turn the printer off, and then press
and hold Go while turning it on. The
printer reads the code on the system
card and bypasses the code on the
firmware card.
Remove the firmware card.
Press Go to clear the message and
continue printing. The job may not
print correctly.
Program new firmware for the
network interface by way of the
parallel port.
Press Menu to open the Job Menu
and reset the printer.
Turn the printer off. Remove the
unsupported option card.
Turn the printer off. Remove the
unsupported option card.
Press Go to clear the message. The
printer discards any data received
through the USB port.
Make sure the USB Buffer menu item
in the USB Menu is not set to
Disabled.
See also: USB Buffer
Turn off and unplug the printer. Remove
the additional drawers. Plug in the printer
and turn it on.
Remove the device and press Go to clear