Sharp LC-30AD1E Operation Manual page 100

HOW TO SET THE FACTORY PRESETS
Press and hold down CLEAR on the AVC System while it is in standby mode. Then press STANDBY/ON
button on the Display or B on the remote control unit to turn the System on.
All setting items (except TV channel) return to the factory presetting.
NOTE
• Running the factory presetting operation also reset the PIN to the factory preset "1234".
You can run the Auto Installation again by using the following steps.
1
Turn on the power of the Display and the AVC System.
2
Press MENU. (Make sure the menu screen displays.)
3
Press c/d to select "Setup".
4
Press a/b to select "Auto Installation", and then press OK.
5
The PIN setting screen displays, you need to enter the factory preset PIN "1234".
–
6
Press c/d to select "Yes", and then press OK.
Yes
The PIN is
NOTE
• As a precautionary measure, make a note of your PIN above, scissor it from this manual, and keep it in a familiar place.
LC-30AD1E(E)-k
– – –
No
.
99 03.10.31, 1:34 PM
99