Mounting The Gps Antenna And Transducers - Navman TRACKFISH 6600 Installation And Operation Manual

16-4 Mounting the GPS antenna and transducers

GPS antenna
Fit the GPS antenna (see section 7) and install
the antenna cable back to the TRACKFISH.
Follow the instructions in the manual supplied
with the antenna. Connect the antenna to
the TRACKFISH:
The cable on the GPS antenna supplied
•
has a plug with a yellow collar. Plug this
into the connector on the back of the
TRACKFISH with a yellow nut. Tighten
the locking collar.
If the GPS source is NavBus or NMEA,
•
see section 16-6.
Sonar transducer
Either:
Fit the transom mount sonar transducer
•
supplied, following the instructions in the
Transom Mount Transducer Installation
Manual supplied with the TRACKFISH.
For enhanced performance, fi t an
•
optional through hull dual frequency
sonar transducer and through hull
speed/temperature transducer.
Contact the nearest Navman dealer for
more information.
The sonar transducer cable has a plug with a
blue collar. Plug this into the connector with a
blue nut on the back of the TRACKFISH.Turn
the collar to lock the connector.
Optional fuel kit
1 Fit the optional fuel kit following the
instructions supplied with the kit.
Note: If the NMEA input on the fuel
sensor cable is used, then a Navman
special fuel cable is required (see section
16-6).
2 Wire the TRACKFISH for auto power (see
section 16-5)
3 The fuel sensor cable has a plug with
a white collar. Plug this plug into the
connector with a white nut on the back of
the TRACKFISH. Turn the collar to lock
the connector.
TRACKFISH 6600 Installation and Operation Manual
NAVMAN
69