Fuel Display - Navman TRACKFISH 6600 Installation And Operation Manual

11 Fuel display

To show the Fuel display, press DISPLAY,
select Other, then select Fuel. The Fuel
display can only be used when the optional
single or twin engine fuel kit has been
installed. See section 15-5 for information
about setting up the fuel display. If the
number of engines is set to 0, the fuel
features are turned off.
TRACKFISH 6600 Installation and Operation Manual
Used shows total fuel used since this was last
reset with the Clear Used command.
R e m a i n i n g shows the amount of fuel
remaining in the tank(s).
Flow shows the fuel consumption per hour.
For twin engine installations, the fuel fl ow for
each engine is shown separately. This is useful
for checking that both engines are under the
same load.
Economy is the distance travelled per unit of
fuel used. The TRACKFISH calculates this from
the boat speed and fuel used. The bigger this
number, the better the fuel economy. Adjust
the throttle and trim to achieve the best fuel
economy. Note that the TRACKFISH uses a
paddlewheel transducer to measure speed,
used to calculate the fuel economy. Therefore,
calibration of the boat speed measurement is
essential for an accurate fuel economy reading.
See section 15-11.
NAVMAN
45