6-1 What comes with this product?
Standard configuration:
FISH 4432/4433 display unit
•
Power cable
•
Mounting bracket (screws included)
•
Warranty registration card
•
This manual
•
Sun cover for display unit
•
Flush mounting kit
•
Dual frequency transom transducer
•
(includes cable kit and screws)
Transom Mount Transducer Installation
•
Manual.
6-2 Options and Accessories
TRACKER series of chartplotters
•
Through hull dual frequency transducer
•
Through hull speed/temperature
•
transducer
Fuel flow kit (single or twin engine)
•
Replacement paddle wheel
•
SmartCraft Gateway*
•
REPEAT 3100 (see section 6-6 Systems of
•
several instruments)*
•
Diesel 3200 for fuel flow on diesel engines*
6-3 Mounting and removing the display unit
There are two mounting arrangements:
Flush mounting requires a solid panel with
•
access behind for wiring and mounting
screws. After flush mounting, the FISH
4432/4433 cannot be tilted or moved after
installation to reduce any unwanted glare
or reflections. Carefully select the best
viewing position before installation. This
would generally be in a shaded area.
Bracket mounting requires a panel for
•
mounting the bracket. Ensure that the
panel is not likely to deform and is not
subject to excessive vibration. The bracket
can be tilted and rotated and the FISH
4432/4433 can be removed after each use.
31
Display unit
Dual frequency
transom transducer
Please consult your Navman dealer for more
information.
* Fish 4433 only
TRACKER
5430 or 5380 chartplotter
Select a position where the display unit will be:
At least 4" (100 mm) away from the compass.
•
At least 12" (300 mm) away from any radio
•
transmitter.
At least 4 ft. (1.2 m) away from any antenna.
•
Easy to read by the helmsman and crew while
•
underway.
Protected from physical damage during
•
rough sea passages.
Easy to access the 12V DC power source.
•
Convenient to route the transducer cables.
•
NAVMAN
FISH 4432/4433 Installation and Operation Manual
Mounting bracket
Screws
Power cable
Fuel flow kit