Samsung VP-DC563i Owner's Instruction Manual page 118

ENGLISH
Troubleshooting
 If these instructions do not solve your problem, contact your
nearest Samsung authorized service certre.
Symptom Explanation/Solution
You cannot switch the Check the Battery Pack or the AC Power

DVD Camcorder on. adapter.
You have left the DVD Camcorder set to

STBY for more than 5 minutes without using
The DVD Camcorder it. To turn on the DVD Camcorder, press the
shuts off automatically. [Start/Stop] button.
The Battery Pack is fully exhausted. Replace

it with a fully charged battery pack.
The atmospheric temperature is too low.

The Battery Pack has not been charged fully.

Charge runs out
The Battery Pack is completely dead, and

quickly.
cannot be recharged, use another Battery
Pack.
The contrast between the subject and

A vertical strip appears the background is too great for the DVD
on the screen when Camcorder to operate normally. Make the
recording a dark background bright to reduce the contrast or
background. use the BLC function while you are recording
in bright Surroundings.
The Viewfinder lens has not been adjusted.

The image in the Adjust the Viewfinder control lever until the

Viewfinder is blurred. indicators displayed on the Viewfinder come
into sharp focus.
Check the Manual Focus menu.

Auto focus does not
Auto focus does not work in the Manual

work.
Focus mode.
When the power is
If the DC Adapter is connected, remove the

turned off and then
cord, turn on the Power switch, and then
turned on, a blue
connect it again. If the battery is connected,
screen appears
disconnect it, turn the Power switch to on,
instead of the normal
and then connect it again.
screen.
118
故障排除
 如果故障没有解决，请与三星授权的当地客服中心联系。
现象 原因/排除方法
您无法打开DVD摄像机的

电源。

DVD摄像机自动关闭。



电量很快耗尽。


在拍摄时暗部背景出现垂
直条纹。

取景器中的影像不清楚。 

自动聚焦功能失灵。


关闭电源然后重新打开
时，将出现蓝屏，而不是
正常的屏幕。
中 文
检查电池组或交流适配器。
您将DVD摄像机设置为超过5分钟不使用
它。若要打开DVD摄像机的电源，请按
下[Start/Stop]按钮。
电池组已完全耗尽电量。请换上完全充
电的电池组。
环境温度太低。
电池组未完全充满电。
电池组已损坏而且不能再充电，请更换
新的电池。
物件与背景之间的对比太大，使DVD摄
像机无法正常操作。被摄体与背景的对
比过大，使本机无法正常操作，提高背
景亮度，减少反差或者使用BLC（背光
补偿）功能。
取景器的镜头尚未调节。
调节取景器的控制杆，直至取景器上显
示的指示符位于强聚焦的范围内。
检查手动聚焦菜单。
手动聚焦模式下，自动聚焦不起作用。
若连接的是交流电源适配器，请拔下电
线，打开电源开关，然后再次连接。若
连接的是电池，请断开连接，将电源开
关转到开位置，然后再次连接。