Frymaster H50 Series Service And Parts Manual page 111

ITEM PART #
1 807-2484
2 810-1372
* 811-0932
3 809-0601
4
810-1767
810-1766
5
901-2772
902-2772
6 813-0165
7 813-0022
8 810-0278
* 900-2935
* 810-1003
9 806-9828SP
10 813-0469
11 810-1360
12 810-1357
13 810-1378
14
901-2214
902-2214
15 826-1366
16 807-2103
17 810-1186
18 826-1377
19 816-0220
20
823-2295
823-2259
21 812-1253SP
NOTE: Left and right refer to the fryer as viewed from the front when facing the fryer.
Shaft 810-1767
(Note orientation of flat
and 45° angle to left.)
(Note orientation of slot)
Valve, Solenoid Vent
Elbow, 90º x ¼-inch NPT x ⅜-inch Tube
Vent Tube, Teflon, ⅜-inch O.D. per foot
Clip, Rod End Clevis
Shaft, Rear Flush Valve
For use in left oil return valve assemblies (see illustration below).
For use in right oil return valve assemblies (see illustration below).
Handle, Rear Flush Valve
For use in left oil return valve assemblies.
For use in right oil return valve assemblies.
Elbow, 90º x ½-inch Street
Nipple, ½-inch Close
Valve, ½-inch Ball
Nut, Oil Return Valve Retainer
Valve, ½-inch 180º 3-way Ball
Flexline Assembly, 9-inch Oil Return
Cap, ½-inch Pipe
Manifold, KFCH250 Rear Flush Oil Return
Manifold, KFCH350 Rear Flush Oil Return
Manifold, KFCH450 Rear Flush Oil Return
Cover, FPH50 Rear Flush Oil Return Microswitch
For use in left handle and switch assemblies.
For use in right handle and switch assemblies.
Nut, 4-40 Keps Hex (Pkg. of 25)
Microswitch
Cam, Filter System Microswitch
Setscrew, 10-32 x ¼-inch (Pkg. of 25)
Insulation, Microswitch
Handle, Rear Flush
For use in Non-CE applications (see illustration below).
For use in CE applications only (see illustration below).
Cover, Rear Flush Handle
Full Vat or
Left Side of Dual Vat
Handle 823-2259
This handle is used in
CE applications.
COMPONENT
Shaft 810-1766
(Note orientation of flat
and 45° angle to right.)
Handle 823-2295
(Note orientation of slot)
This handle is used in
non-CE applications.
NOTE: Handles are shown in
Valve OPEN/Filter ON position.
2-48
Right Side of Dual Vat