Rating Plate; Pre-Installation - Frymaster FPHD65 Installation & Operation Manual

Decathlon series gas fryer
Table of Contents

Advertisement

HIGH EFFICIENCY DECATHLON (HD) SERIES GAS FRYERS

2.5 Rating Plate

This is attached to the inside front door panel. Information provided includes the model and serial
number of the fryer, BTU/hr input of the burners, outlet gas pressure in inches W.C. and whether the
unit has natural or propane gas orifices.
Fryers MUST be connected ONLY to the gas type identified on the attached rating

2.6 Pre-installation

No structural material on the fryer should be altered or removed to accommodate
placement of the fryer under a hood. Questions? Call the Dean Service Hotline at 1-
Do not connect this appliance to the gas supply before reviewing all information in
A. General: Only licensed personnel should install any gas-fired equipment.
1.
A manual gas shut-off valve must be installed in the gas supply line ahead of the fryers for
safety and ease of future service.
2.
Dean Decathlon Series gas fryers require 120VAC 60 cycle or 230VAC single-phase 50 Hz
(International) electrical service and are equipped with a 16-3 SJT grounded flexible power
cord for a direct connection to the power supply. Amperage draw for each unit depends on
the accessories supplied with the unit/system.
B. Clearances: The fryer area must be kept free and clear of all combustibles. This unit is design-
certified for the following installations:
1.
Commercial installation only (not for household use).
2.
Non-combustible floor installation equipped with factory-supplied 6 in. (15 cm) adjustable
legs or 5 in. (13 cm) casters;
3. Combustible construction with a minimum clearance of 6 in. (15 cm) side and 6 in. (15 cm)
rear, and equipped with factory-supplied 6 in. (15 cm) adjustable legs or 5 in. (13 cm)
casters.
CHAPTER 2: IMPORTANT INFORMATION
DANGER
plate.
DANGER
800-551-8633.
DANGER
this chapter.
2-3

Advertisement

Table of Contents
loading

Table of Contents