Installing The Driver Locally - Samsung SCX-465x Series User Manual

Installing the driver locally

A locally connected machine is a machine directly attached to your computer
using the cable. If your machine is attached to a network, skip the following
steps below and go on to installing a network connected machine's driver (see
"Installing driver over the network" on page 138).
• If you are a Macintosh or Linux operating systems user, refer to the
"Installation for Macintosh" on page 129
page 131.
• The installation window in this
machine and interface in use.
• Selecting Custom Installation
install.
• Only use a USB cable no longer than 3 meters (118 inches).
15
Windows
1 Make sure that the machine is connected to your computer and
powered on.
If the "Found New Hardware Wizard" appears during the installation
procedure, click Cancel to close the window.
or "Installation for Linux" on
User's Guide may differ depending on the
allows you to choose which programs to
2 Insert the supplied software CD into your CD-ROM drive.
If the installation window does not appear, click Start > All programs >
Accessories > Run.
X:\Setup.exe replacing "X" with the letter, which represents your CD-
ROM drive and click OK.
3 Select Install Now.
4 Read the License Agreement, and select I accept the terms of the
License Agreement. Then, click Next.
Follow the instructions in the installation window.
5
30
1. Introduction