Equipment Setup And Shutdown Procedures - Frymaster BIH1721 Series Installation & Operation Manual

2.5 Equipment Setup and Shutdown Procedures

Setup
Fill the frypot to the bottom OIL LEVEL line with oil before pressing the ON/OFF
switch to the "ON" position.
elements.
1. Fill the frypot with oil to the bottom OIL LEVEL line located on the rear of the frypot. This will
allow for oil expansion as heat is applied. Do not fill cold oil any higher than the bottom line;
overflow may occur as heat expands the oil. If solid shortening is used, first raise the elements,
then pack solid shortening into the bottom of the frypot. Lower the elements, and then pack
solid shortening around and over the elements. Never insert a solid block of shortening into
frypot on top of the elements. Hot spots and element damage will occur, and the potential for
flash-fire increases.
NEVER set a complete block of solid shortening on top of heating elements. To do
so will damage the elements and increase the potential for flash-point shortening
temperatures and subsequent fire.
2. Ensure that the power cord(s) is/are plugged into the appropriate receptacle(s). Verify that the
face of the plug is flush with the outlet plate, with no portion of the prongs visible.
3. Ensure that the oil level is at the top OIL LEVEL line when the oil is at its programmed cooking
temperature. It may be necessary to add oil to bring the level up to the proper mark, after the oil
has reached the programmed cooking temperature. If solid shortening is used, the MELT cycle
MUST be used exclusively to melt the shortening. It may be necessary to add solid shortening
to bring the level up to the proper mark after the packed shortening has melted. DO NOT
DISABLE OR CANCEL THE MELT CYCLE.
Shutdown
1. Press the ON/OFF switch
computer is used. If using a CMIII.5, the display will be blank.)
2. Filter oil (if applicable) and clean fryers (See Chapter 3).
3. Place the frypot covers on frypots.
EH1721 SERIES ELECTRIC FRYERS
CHAPTER 2: INSTALLATION INSTRUCTIONS
WARNING
Failure to do so could damage the frypot and
WARNING
to the "OFF" position. (The display will show "OFF" if the CM4-S
2-7