Loading Paper In The Bypass Tray - Xerox DocuPrint C2100 Quick Reference Manual

Loading Paper in the Bypass
Tray
In addition to plain paper, the bypass tray can use
various other sizes and types of print media such
as envelopes and transparencies.
Make sure of the following points when loading
paper in the bypass tray.
• You can load up to 150 sheets or a stack of
2
paper (60 g/m to 216 g/m
high.
• The bypass tray accepts print media within the
following dimensions:
- Width: 76.2 mm to 220.0 mm
- Length: 98.0 mm to 355.6 mm
• You can load paper up to 355.6 mm long. When
a mismatch of paper sizes occurs, follow the
instructions displayed on the control panel.
Important
• Make sure of the following points to avoid any troubles
during printing.
• Do not load different types of paper at the same time.
• Use high quality paper for laser printers to print at high
quality. Refer to "About Paper" (P. 22) for details.
• Do not remove or add paper to the bypass tray when
printing or if there is any paper still in the bypass tray.
Doing so may cause a paper jam.
• Do not put any objects other than paper on the bypass
tray. Also, do not push or force down the bypass tray.
1. Gently pull open the bypass tray cover, and
pull out the extension tray.
26
4 About Paper
2
) less than 15 mm
2. Slide the width guides to the edge of the tray.
The width guides should be fully extended.
3. Insert all media face down and top edge first
into the bypass tray.
Important
• Do not force the paper.
4. Slide the width guides until they rest lightly
against the edge of the paper stack.
Important
• Be careful not to bend the paper.