Reset Arp - Motorola Netopia 2200 Administrator's Handbook

netstat -i
Displays the IP interfaces for your Motorola Netopia® Gateway.
netstat -r
Displays the IP routes stored in your Motorola Netopia® Gateway.
nslookup [ hostname | ip_address ]
Performs a domain name system lookup for a specified host.
◆
The argument is the name of the host for which you want DNS information; for example,
hostname
nslookup klaatu
.
◆
The argument is the IP address, in dotted decimal notation, of the device for which
ip_address
you want DNS information.
ping [-s size ] [-c count ] [ hostname | ip_address ]
Causes the Motorola Netopia® Gateway to issue a series of ICMP Echo requests for the device with the
specified name or IP address.
◆
The hostname argument is the name of the device you want to ping; for example,
pia.com
.
◆
The argument is the IP address, in dotted decimal notation, of the device you want to
ip_address
locate. If a host using the specified name or IP address is active, it returns one or more ICMP Echo
replies, confirming that it is accessible from your network.
◆
-s
The argument lets you specify the size of the ICMP packet.
size
◆
-c
The argument lets you specify the number of ICMP packets generated for the ping
count
request. Values greater than 250 are truncated to 250.
You can use the ping
your network. You cannot use the
address.
quit
Exits the Motorola Netopia® Gateway command line interface.

reset arp

Clears the Address Resolution Protocol (ARP) cache on your unit.
reset atm
Resets the Asynchronous Transfer Mode (ATM) statistics.
reset cdmode
This command will set up one boot flag so that the next time a 3342N/3352N restarts or reboots
(power cycle), the Gateway will boot into CD-ROM mode instead of Gateway mode.
command to determine whether a hostname or IP address is already in use on
ping command to ping the Motorola Netopia® Gateway's own IP
ping ftp.neto-
131