Led Function Summary Matrix - Motorola Netopia 2200 Administrator's Handbook

Administrator's Handbook

LED Function Summary Matrix

Unlit
No power
Power
No signal
USB Active
No signal
DSL Sync
No signal
DSL Traffic
No signal
Ethernet
Traffic
No signal
Ethernet Link
No signal
Internet
Wireless is
Wireless
disabled.
If a status indicator light does not look correct, look for these possible problems:
LED State
1.
2.
Power Unlit
3.
4.
1.
2.
DSL
Unlit
3.
Sync
4.
5.
Note: EN Link light is inactive if only using USB.
1.
2.
3.
EN Link Unlit
4.
5.
120
Solid Green
Power on
USB port con-
nected to PC
DSL line synched
with the DSLAM
N/A
N/A
Synched with Ether-
net card
Broadband device
is connected.
Wireless is
enabled.
Make sure the power switch is in the ON position.
Make sure the power adapter is plugged into the 2200-, 3300- or 7000-series DSL Gate-
way properly.
Try a known good wall outlet.
Replace the power supply and/or unit.
Make sure the you are using the correct cable. The DSL cable is the thinner standard tele-
phone cable.
Make sure the DSL cable is plugged into the correct wall jack.
Make sure the DSL cable is plugged into the DSL port on the 2200-, 3300- or 7000-series
DSL Gateway.
Make sure the DSL line has been activated at the central office DSLAM.
Make sure the 2200-, 3300- or 7000-series DSL Gateway is not plugged into a micro filter.
Make sure the you are using the Ethernet cable, not the DSL cable. The Ethernet cable is
thicker than the standard telephone cable.
Make sure the Ethernet cable is securely plugged into the Ethernet jack on the PC.
If plugging a 2200-, 3300- or 7000-series DSL Gateway into a hub the you may need to
plug into an uplink port on the hub, or use an Ethernet cross over cable.
Make sure the Ethernet cable is securely plugged into the Ethernet port on the 2200-,
3300- or 7000-series DSL Gateway.
Try another Ethernet cable if you have one available.
Flashing
Solid Red
Green
N/A System failure
Activity on the N/A
USB cable
Attempting to N/A
train with DSLAM
Activity on the N/A
DSL cable
Activity on the N/A
Ethernet port
N/A N/A
Activity on the Physical link
WAN port. established, but
PPP or DHCP
fails.
Activity on the N/A
WLAN.
Possible problems
Flashing Red
Installing new
embedded software
N/A
N/A
N/A
N/A
N/A
N/A
N/A