Deleting A Filter Set; A Sample Filter Set - Motorola Netopia Embedded Software Handbook

10-32 Administrator's Handbook
Enter the IP specific information for this filter.
Deleting filters
To delete a filter, select Delete Input Filter or Delete Output Filter in the Display/Change Filter Set screen to
display a table of filters.
Select the filter from the table and press Return to delete it. Press Escape to exit the table without deleting the
filter.
Moving filters
To reorganize the filters in a filter set, select Move Input Filter or Move Output Filter in the Display/Change
Filter Set screen to display a table of filters.
Select a filter from the table and press Return. Then use the up or down arrow key to change the filter's order in
the filter set. Press Return to accept the new filter location.
Deleting a filter set
Note:
If you delete a filter set, all of the filters it contains are deleted as well. To reuse any of these filters in
another set, before deleting the current filter set you'll have to note their configuration and then recreate them.
To delete a filter set, select Delete Filter Set in the Filter Sets screen to display a list of filter sets.
Select a filter set from the list and press Return. Select CONTINUE and press Return to delete it.
A sample filter set
This section contains the settings for a filter set called Basic Firewall, which is part of Motorola Netopia®
Embedded Software Version 8.7.4's factory configuration.
Change Filter
Enabled:
Forward:
Source IP Address:
Source IP Address Mask:
Dest. IP Address:
Dest. IP Address Mask:
Protocol Type:
Source Port Compare...
Source Port ID:
Dest. Port Compare...
Dest. Port ID:
No
No
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0
No Compare
0
No Compare
0