Valet® Mode; Remote Valet - Viper 280HF Owner's Manual

Valet® Mode
You can prevent your system from automatically arming and trig-
gering by using Valet Mode. This is very useful when washing the
vehicle or having it serviced. In Valet Mode, the system will not
arm, even with the transmitter, but all convenience functions
(door locks, trunk release, etc.) will work normally.
To enter or exit Valet Mode with the Valet switch:
Turn ignition to "run" position, then
turn to "off" position. Press and
release the Valet switch within 10
seconds. The Status LED will light
steady if you have entered Valet
Mode, and it will go out if you exit-
ed Valet Mode.

Remote Valet

You can also activate Valet
Using Remote Valet as you enter or exit the vehicle:
1. Open any door.
2. Press (or the arm/disarm button).
3. Press (or the function 2 Button).
4. Press again.
The Status LED will light steady if you have entered Valet Mode,
and it will go out if you have exited Valet Mode.
10
® Mode using the remote transmitter.
1999 Directed Electronics, Inc.
©
DRW-35