Main Beam Headlamps - Alfa Romeo 156 Owner's Manual

The Xenon lamp must be
handled touching only the
metallic part. If the trans-
parent bulb is touched with the fin-
gers, rub it with a clean cloth
moistened with methylated spir-
its and allow to dry before refit-
ting the bulb.
WARNING Once the operation has been
completed, turn dipped beam headlamps on
and check that the headlight parabola
moves when positioning the light itself. If
not, re-engage the lamp.
222
– Turn ring (A-fig. 26) counter-clock-
wise and remove it.
– Remove the Xenon lamp (B-fig. 26).
– Fit the new bulb by placing it so that the
notch matches the groove on its housing.
– Refit the protective cover correctly
(A-fig. 23).
fig. 26

Main beam headlamps

To replace the bulb proceed as follows:
– Turn the protective cover counter-clock-
wise (C-fig. 23) in order to reach the high-
beam headlight bulb (A-fig. 24).
– Remove connector (A-fig. 27) and re-
move the bulb operating the clips (B) as
shown in the figure.
– Fit the new bulb.
– Refit the protective cover correctly (C-
fig. 23).
A0B0352m
fig. 27
A0B0350m