Table of Contents
Advertisement
C H A P T E R
Connecting an Antenna/Cable and VCR to Your TV
Your TV will provide you with the best performance if you connect it to an external anten-
na or cable system. Follow the directions below to make this connection. Please note that
you will normally only have to make one of the connections shown below, not all of them.
All connections will be made to the antenna terminal on the back of your TV. The antenna
terminal is a silver metal post partially surrounded by two plastic tabs. For help in locating
the antenna terminal, see "Your TV's Back View" on page 7.
Connecting an Antenna
If your antenna ends in a pair of 300 ohm twin leads, you must use a 300-ohm/75-ohm
adapter. Place the leads underneath the screws on the adapter, tighten the screws, then press
the adapter onto the antenna terminal on the back of the TV.
3
Chapter 1 : Connecting an Antenna/Cable and VCR to Your TV
1
If your antenna ends in a single coaxial lead,
simply press or screw the cable onto the antenna
terminal on the back of your TV.
Advertisement
Table of Contents
