How To Clean The Unit After Inhalation - Omron Micro A-I-R NE-U22 Instruction Manual

EN-p2-20-(NE-U22)-3

How to Clean the Unit after Inhalation

Be sure to clean and store the unit after inhalation.
If you do not clean the unit after inhalation, medication will be dried and
adhered, and will not nebulize normally the next time. If this happens, clean the
Mesh Cap by boiling to wash off the adhered medication.
1 Remove the parts from the Main Unit.
Remove Inhalation Mask or Mouthpiece, Mask Adapter, and
Medication Bottle from the Main Unit.
2 Discard the remaining medication.
After removing the Mesh Cap, open the Medication Bottle
Cap and discard the medication.
(1)
Lift up the Mesh Cap by
applying your thumb on
the brim.
3 Wash the parts sufficiently in water.
Wash Inhalation Mask or Mouthpiece, Mask Adapter,
Medication Bottle, and Mesh Cap in water.
- Carefully wash the Mesh when using a medication
having high surface activity or viscosity such as
medication solubilizing agent or expectorant because
the medication is often left on the Mesh.
- Please be careful not to spray water on the Main Unit.
3/25/02 4:48 PM Page 14
Lift up the
Mesh Cap
perpendicular
to the
Medication
Bottle.
Do not insert your
finger into the
Nebulization Port.
(Refer to Page 9.)
(Refer to Page 9.)
(2)
Discard the
remaining
medication.
14
(Refer to Page 16.)
Disengage the
Medication Bottle Cap
Locking Lever and
open the Medication
Bottle Cap.
(3)