Handle Mecha; Removing The Control Panel - Sega Jumbo!Safari Owner's Manual

8. HANDLE MECHA

In order to prevent an electric shock and short circuit, be sure to turn power off before performing
work by touching the interior parts of the product.
Be careful so as not to damage wirings. Damaged wiring can cause an electric shock or short circuit
accident.
In the test mode, if the steering wheel's VR variations are not within the allowable range, the VR installation
position adjustments or VR replacement is needed. Also, be sure to apply grease to the VR gear portion once
every 3 months.

8 - 1 REMOVING THE CONTROL PANEL

1 Turn the power switch off.
Remove a total of 4 tamperproof screws from both sides of the control panel's front.
2
3
Remove the two tamperproof screws fromthe underside of the control panel.
4
Wiring connectors are connected inside the control panel. Carefully draw the control panel in a mnner so as not to
damage wiring.
Disconnect the wiring connector.
5
31
www.seuservice.com