Troy-Bilt Squall2100 Operator's Manual page 8

2. Align the holes in the chute base with the holes in the
lower chute and secure with the previously removed hex
washer screws. See Fig. 3-4.
Installing the Chute Rotation Control (If so equipped)
To install the chute rotation control (only models so equipped)
proceed as follows:
1. Remove the hex lock nut and machine screw from the
chute rotation control. See Fig. 3-5.
1
Hex Lock
Nut
Machine Screw
Chute Control Rod
2. Place the chute rotation control onto the chute rotation
rod and secure with the hex lock nut and machine screw
removed in step 1. See Fig. 3-5.
8 S 3— A
ection SSembly
Figure 3-4
Chute Rotation Control
2
Hex Lock
Nut
Machine Screw
Figure 3-5
& S -U
et p
Installing the Drift Cutters (If so equipped)
1. Remove the carriage bolts and flange lock nuts from the
drift cutters.
2. Install the drift cutters and secure with the carriage bolts
and flange lock nuts removed in step 1. See Fig. 3-6.
Figure 3-6
Installing the Recoil Starter Handle
1. Remove the eye bolt and handle knob from the manual
bag.
2. Place the eye bolt and handle knob on the upper handle
as shown in Fig. 3-7. Do not fully tighten the hardware until
instructed to do so.
Eye Bolt
Handle
A
Knob
Figure 3-7
NOTE: The opening of the eye bolt should face toward the
back of the snow thrower.
Drift Cutter
Flange Lock Nut
Carriage Bolt
Recoil Starter
Handle
B