UNI-T UT50D Operating Manual page 35

Table of Contents

Advertisement

To replace the Meter's fuse:
1. Disconnect the connection between the testing leads
and the circuit under test, and remove the testing
leads away from the input terminals of the Meter.
2. Turn the Meter off.
3. Remove the rubber feet and screws from the case
bottom, and separate the case bottom from the case
top.
4. Remove the fuse by gently prying one end loose, and
then take out the fuse from its bracket.
5. Install ONLY replacement fuses with the identical type
and specification as follows and make sure the fuse
is fixed firmly in the bracket.
0.5A. 250V fast type fuse, 5x20mm
6. Rejoin the case bottom and the case top, and install
the screw and rubber feet
Replacement of fuses is seldom required. Burning
of a fuse always results from the improper operation.
This operating manual is subject to change without notice.
Model UT50D: OPERATING MANUAL
~ END ~
35

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents