Canon Mk1500 User Manual page 52

Attaching the wrap-around tape
1.
When wrapping, the laminating cover should overlap the printed part suffi ciently. We
therefore recommend using with cable of φ 3 to φ 7.6 mm.
2.
3.
If the film does not peel away from the backing
Because wrap-around tape has a strong adhesive, it may be hard to peel the fi lm off the
backing. Refer to the following diagram for the peeling method.
If the cut is too shallow
Wrap-around tape is thicker than typical label tape, so the half-cut may be shallower.
In this case, refer to "What To Do If the Cutter Is Getting Blunt" on page 96 to adjust cutting
depth. If it still does not cut, replace with new cutter. (
If the half-cut is too shallow, the fi lm may not peel from the backing properly.
Nisca Corporation shall not be responsible for damages that might result from
the tape peeling off, or from fading of the printing on the tape.
48
Peel the printed film from the wrap-around tape backing.
Attach the tape to the cable as shown in the diagram,
starting from the printed end.
Wrap the transparent laminating portion so that it covers
the printed part.
Peel-off Film
Printable Area
If this part is joined, pull apart with your
fingers
If the remaining part cannot be separated, adjust the
cutting depth.
Hold the backing
Peel the printed part away
page 98)
Printable Area