Connections - Cambridge Audio AZUR 351A User Manual

Connections

Loudspeakers
Check the impedance of your speakers. When using a pair of speakers,
you can use types with an impedance of between 4 and 8 Ohms.
The red coloured speaker terminals are positive (+) and the black speaker
terminals are negative (-). Make sure correct polarity is maintained at
each speaker connector or the sound can become weak and "phasey"
with little bass.
Using bare wire connections
Prepare the speaker cords for connection by stripping off approximately
10mm (3/8") or less of the outer insulation. More than 10mm could
cause a short circuit. Twist the wires tightly together so there are no
loose ends. Unscrew the speaker terminal, insert the speaker cable,
tighten the terminal and secure the cable.
Right
speaker
Amplifier
CD player
Record out connection
The diagram below shows how to connect the amplifier to a tape recorder
or other component with a record function. Please note that either of the
record outputs can be used (as they are both the same signal in parallel).
Right
speaker
Amplifier
Tape/MD player
8
Black Red
S1 S2 S3 S4 S5 Out Rec
Left Left
Right Right
S1 S2 S3 S4 S5 Rec Out
S1 S2 S3 S4 S5 Out Rec
Left Left
Right Right
S1 S2 S3 S4 S5 Rec Out
Note: All connections are made using standard loudspeaker cable.
Basic connection
The diagram below shows the basic connection of your unit to a CD
player and a pair of loudspeakers.
Red Red
Right A Left Right B Left
USB Audio In
A B
Right Left Right Left
Loudspeaker Terminals
Black Black
Right A Left Right B Left
USB Audio In
Right A Left Right B Left
Loudspeaker Terminals
Left
speaker
Black Red
Mains Voltage
Selector Switch:
115V/220-230V
AC~50/60Hz
Power AC
left
speaker
Mains Voltage
Selector Switch:
115V/220-230V
AC~50/60Hz
Power AC