Short Instructions; More Natural Sound By; If The Setting Remains Unchanged Within - Blaupunkt Montreal RCM 45 Operating Instructions Manual

Short instructions

1 On
Off
Volume
This unit can also be switched on and
off with the Release Panel C.
Also, when being connected correctly,
you may turn the radio on and off via
the ignition of your car.
Use one of the following possibilities to
continue operating the set when the
ignition is switched off:
a) Switch on/off with knob 1.
b) Remove/re-install the release panel.
c) Press AUD 3.
When turning on the unit with the re-
lease panel or by pressing the AUD
button, the system will start to play with
the volume adjusted last.
When operating the unit with the igniti-
on being switched off, the system will
automatically shut down after one hour
in order to avoid that the battery goes
flat.
2 LD
Loudness - When listening at a low
level, the Loudness function creates a
more natural sound by boosting the low
frequency range.
To switch the Loudness on/off:
Press LD.
For more information, read chapter
"DSC programming".
3 AUD/GEO
AUD –
To adjust the treble and bass frequen-
cies with the rocker switch.
Treble +
Treble –
Bass –
Bass +
GEO –
To adjust the balance (left/right) and
fader (front/rear) with the rocker switch.
Fader front
Fader rear
Balance left
Balance right
To alter a setting,
• press AUD or GEO and then chan-
ge the value with the rocker switch.
The adjusted value is indicated in the
display.
The last setting will be stored automati-
cally.
To finish the setting: Press AUD or
GEO.

If the setting remains unchanged within

8 seconds, the display will switch back
to the previous condition.
19