Automatic Seek Tuning Start; Adjusting The Volume For Traffic Announcements And The Warning Beep; Tape Operation; Inserting A Tape - Blaupunkt Montreal RCM 45 Operating Instructions Manual

Automatic seek tuning start

(tape operation)

When leaving the reception area of the tuned
in traffic programme station while listening to
a tape, the system will automatically start
searching for a new TA programme.
If no such station is found within approxima-
tely 30 seconds, tape operation will be stop-
ped and a warning beep will sound.
To switch the warning beep off, proceed as
described above.
Adjusting the volume for traffic
announcements and the warning
beep
This volume was preset at the factory.
You can alter the value using the DSC function
(see "DSC programming, TA").
Tape operation

Inserting a tape

• Turn on the set.
• Insert a tape.
Insert the tape with side A or 1 showing up, the
open side facing to the right.
= Press to eject the tape.
The tape will be played in the direction used
last.
"TR1--..." in the display means that track 1 or
A is being played.

Removing a tape

• Press .
The cassette will eject.

PROG selector

(To change the tape direction during
cassette playback)
• Press FR and FF simultaneously.
At the end of a tape side, the mechanism
changes directions automatically to play the
other side (Autoreverse). The display shows
"TR1--..." for track (side) 1 or A or "TR2--..."
for track 2 or B.
Notice:
If there is too much tension on the tape during
playback, the set may switch over by itself
before having reached the end of the tape
side. In this case check the condition of the
cassette tape. Sometimes it helps to rewind
it completely.

Fast Forward/Rewind

Fast Forward
• Press FF.
At the end of a tape side, the mecha-
nism changes directions automatically
to play the other side.
Stopping Fast Forward operation
• Press FR.
Fast Rewind
• Press FR.
At the beginning of the tape, the me-
chanism will automatically start play-
back.
Stopping Fast Rewind operation
• Press FF.
29