Installation - Binatone Acura 3000 User Manual

2. Installation

1. Locating the Base unit
The Base unit should be placed on a level surface, in a position where:
the mains adapter plug will reach an easily accessible 230-V AC
switched mains supply socket - never try to lengthen the mains power
cable.
the telephone line cable will reach your telephone line socket or
extension socket.
it is not close to a sink, bath or shower, or anywhere else where it
might get wet.
it is not close to other electrical equipment - fridges, washing
machines, microwave ovens, TVs, fluorescent lights, etc.
2. Plug the coiled handset cord into the Handset. Plug the other end into
the socket on the side of the Base unit.
3. Place the Handset on
the Base unit.
4. Plug the telephone line cord into
the PHONE LINE socket at the
back of the Base unit. Plug the other
end into your telephone line socket
or extension socket.
RINGER
HI/LOW
switch
Always use the telephone line
cord supplied with your Phone.
Other telephone line cords may
not work.
Note: The Acura 3000
Base unit must be used only
with the AC power adapter
Shen Zhen G.EREDIT Electronics Co.,Ltd.
5E-AD070042-B.
Note: The base unit doesn't require a battery.
5. Plug the power supply cord into
the POWER jack at the back of
the Base unit. Plug the other end
into a 230V AC, 50Hz mains
socket, with the switch on the
socket set to OFF
6. Switch ON the mains power at
to Telephone
the socket. Wait while the
line socket display shows INITIALISATION,
then the announcement
"Answering machine on.
Announcement one"
before the display changes to the
standby screen.
7.Lift the Handset and check
for Dial tone in the earpiece.
4
Make sure the plugs
click into place.