1.0 Introduction Description 1. The Baxi Ecogen 24/1.0 is a fully automatic gas fired wall mounted condensing heat only boiler which will produce up to 1kW of electricity for use by the householder. Any electricity excess to requirements at the time of production will be fed back into the national grid.
4.0 Technical Data Ecogen 24/1.0 and Ecogen 24/1.0 LPG Country - GB/IE - Natural Gas Appliance Category CAT I Appliance Type NO x Class Max Gas Rate (m /hr) Central Heating Primary Circuit Both 2.68 Engine 0.82 Supplementary 1.86 Electrical Supply...
Fernox for analysis to confirm the system cleaning and dosing process has been successful. A copy of the report to be sent to Baxi Heating UK Ltd, heateam, Ecogen team, Brooks House, Coventry Road Warwick CV3 4LL.
Page 18
An example of the warning label to be left on site is shown (Fig. 12a). Fig. 12a 10. There are two ways in which the Ecogen 24/1.0 appliance can be electrically installed. Connection by dedicated circuit (Fig. 13) Connection into an existing final circuit (Fig.
Page 19
IMPORTANT: In designing a connection for the Ecogen 24/1.0 the electrical installer has to 7.0 Site Requirements consider all the issues that would need to be covered for a conventional final circuit, including:- In Accordance with BS: 7671. • the maximum demand (and the generator output) Electrical Connection (cont) - Installer information •...
9.0 Installation NOTE: - Installers of this appliance must have undergone Baxi Ecogen Training and been approved to install this appliance. Unpacking & Initial Preparation NOTE: Maintain the appliance upright at all times. Do not lay the appliance on its back, sides or front. Drilling of the wall or ceiling for flue and pipe work must be completed before the appliance is fitted to the wall.
Benchmark Commissioning Checklist at the rear of this publication. NOTE: Service and maintenance engineers must have PINT undergone Baxi Ecogen Training and been approved to service this appliance. 3. Before electrically isolating the appliance: remove all demands Inlet Test Gas Valve for heat and ensure the engine has disconnected from the grid.