Release M.10.36; Release M.10.37; Release M.10.38 - HP ProCurve Series 3400cl Release Notes

Software Fixes in Release M.08.51 - M.10.72

Release M.10.36

BPDU Protection (PR_1000395569) — BPDU-protection fails after module hot-swap.
■
■ Enhancement (PR_1000419928) — The Dynamic ARP Protection feature was added.
■ IP Connectivity (PR_1000418378) — The switch incorrectly updates its ARP table when
a client that is configured with a valid IP address for a valid VLAN, is connected to a port in
another VLAN on the switch. This will result in loss of connectivity for the valid client in the
appropriate VLAN.
Release M.10.36
Problems Resolved in Release M.10.36 (Never released)
Releases M.10.36 was never built.

Release M.10.37

Problems Resolved in Release M.10.37
■ sFlow (PR_1000396889) — If the sflow skip count is set greater than the maximum skip
count or less than minimum skip count, the switch returns an error, preventing PCM from
collecting sampling data.
■ Enhancement (PR_1000369492) — Update of the MSTP implementation to the latest
IEEE P802.1Q-REV/D5.0 specifications to stay in sync with the protocol evolution.

Release M.10.38

Problems Resolved in Release M.10.38 (Not a General Release)
■ TFTP (PR_1000426821) — TFTP transfers do not work when there is no IP address
configured for VLAN 1.
PIM-DM (PR_1000398231) — PIM Dense Mode can trigger unicast routing issues on local
■
hosts.
Enhancement (PR_1000428642) — SNMP v2c describes two different notification-type
■
PDUs: traps and informs. Prior to this software release, only the traps sub-type was
supported. This enhancement adds support for informs.
SNMP (PR_1000406398) — URL embedded SNMP traps are not sent as SSL (https) when
■
SSL is enabled, but are sent as plain-text (http) instead. This may result in the trap receiver
(e.g. PCM) not being able to display the URL if SSL is enabled.
172