FOLSOM PresentationPRO PS-2001 Installation And Operator's Manual page 7

Step 3: Connect Audio Outputs
Connect the Audio Out signals to an appropriate audio amplifier.
Step 4: Power Up
Connect PresentationPRO to 115 VAC power using the power cord supplied with the unit. Locate the power switch on the power entry
module at the rear of the unit and turn the power on. While the main board is initializing, "please wait" will be displayed and the front
panel keys will be turned on and off. When initialization is complete, the front panel display will indicate that the unit has powered up
successfully. The Set Up Menu is displayed when the initialization process is complete.
Step 5: Select Desired Output Format
An arrow ">" will be displayed nex
key. An arrow ">" will be displayed next to "Format." Press the
o utput resolutions. Stop on the desired output resolution and press SEL. The output is now set to the desired output format. Other
selections in the ou tput Set Up Menu are Frame Rate, Sync Type, Test Patterns, and Raster Box. All Of the functions needed to ensure
proper output display device compatibility.
Press the ESC key to leave the Output Setup menu.
Step 6: Projector Adjustments
P roper projector setup is critical to optimize the quality of the output image. Once PresentationPRO's output is set to match the native
resolution or "sweet spot" of the projector,
The methods to disable the internal Scaler within the projector vary from manufacturer to manufacturer. Please consult the operator's
manual for your equipment. PresentationPRO's Output Setup menu allows the user to select test patterns that are used during projector
adjustment.
S tep 7: Configure Input Sources
PresentationPRO will automatically lock to video app
(R GB, YUV, S-Video, NTSC) and all associated video parameters. While the "best guess" approach generally leads to an acceptable
output image, it is strongly reco
with each input before conducting a presentation. The use of configuration files provides consistent, repeatable operation and allows the
user to adjust video parameters for each source to optimize image quality. Each time a source is s
th e configuration file associated with that source is automatically reloaded.
Setting up input configuration files is simple. Proceed as follows for each input.
1. Select the so
2. Enter the INPUT SETUP menu. Examine the image on the projector or other display device and adjust the input
parameters as desired. The Input Setup menu is described in detail on page 16 of this manual. Many of the parameters may
require no adjustment, however, be sure that the INPUT TYPE menu item is selected to match the incoming source.
3. When the input setup parameters have been set as desired, press Save. The setup information is automatically
assigned to the source used for the input setup process. The inpu
time the source is selected.
NO TE: When ever a modification is made to a configura
This is a quick reference guide. For detailed information on the PresentationPRO
Folsom Research, Inc. · 11101-A Trade Center Drive, Rancho Cordova CA 95670 · (916) 859-2500 ·
t to "Input A/V Setup." Scroll down using the ADJUST control to "Output Video Setup." Press the SEL
the scaling engine in the projector should be disabled.
lied to the seven universal inputs and will make a "best guess" at the video format
mmended that the user set up a configuration file to precisely define the video parameters associated
urce you wish to work with.
Installation and Operating Manual supplied with your unit.
SEL key. Rotating the ADJUST control will scroll through the available
t configuration file will automatically be recalled for use each
tion, you must resave the changes following the procedure above.
elected with the Source Selection keys,
ä
, please refer to the
www.folsom.com