FOLSOM PresentationPRO PS-2001 Installation And Operator's Manual page 16

Rack-Mount Installation
PresentationPRO units are designed to be rack mounted and are supplied with front rack-mount hardware. Rear
rack-mount brackets are available as a kit and are recommended for use when units are mounted in transit cases.
When rack mounting the unit, remember that the maximum ambient operating temperature for the unit is 40 degrees
C. Leave at least one inch of space front and rear to make sure that the airflow through the fan and vent holes is not
restricted. When installing equipment into a rack, distribute the units evenly to prevent hazardous conditions that may
be created by uneven weight distribution. Connect the unit only to a properly rated supply circuit. Reliable grounding
(earthing) of rack-mounted equipment should be maintained.
Power Cord/Line Voltage Selection
PresentationPRO is rated to operate with the following supplies:
Input Power:
Power Consumption :
The PresentationPRO High Resolution Seamless Switcher performs line voltage selection automatically. No user
controls are required for line voltage selection.
WARNING
AVERTISSEMENT
AVERTISSEMENT
Manual # 26-0006901-00 / Revision E
115-230 VAC, 47-63 Hz
125 watts maximum
When the PresentationPRO is used with 230-volt supplies, a UL listed line cord rated
for 250 volts at 15 amps must be used. This cord will be fitted with a tandem prong-type
plug.
Figure 5-2: Tandem Plug
La choix de la ligne de voltage se realize automatiquement par I'PresentationPRO
Transformateur Graphique On n'apas besoin du controller usager pour la choix de la ligne
de voltage.
Das PresentationPRO-Gerät mu beim Anschlu an 240V ~ mit einer vom VDE auf
250V/10A geprüften Netzleitung mit einem Schukostecker ausgestattet sein.
PresentationPRO – A/V Seamless Switcher
7