Sewing An Embroidery Pattern; Sewing Attractive Finishes; Embroidery Needle Plate Cover - Baby Lock Ellegante2 BLG2-NZ Instruction And Reference Manual

Limited signature edition

Table of Contents

SEWING AN EMBROIDERY PATTERN

Sewing Attractive Finishes

There are many factors that go into sewing beautiful embroidery. Using the appropriate stabilizer (see

page 157) and hooping the fabric in the frame (see page 158) are two important factors mentioned earlier.

Another important point is the appropriateness of the needle and thread being used. See the explanation

of threads below.

Thread

Upper thread Rayon, polyester, or cotton embroidery thread is recommended for use with this machine.

Other embroidery threads may not yield optimum results.

Bobbin thread Use embroidery bobbin thread intended for use with this machine.

When using other kinds of embroidery bobbin thread, use the alternate bobbin case (pink screw) included

with this machine (the bobbin case originally installed in the machine has a green screw). (See page 226 for

how to remove the bobbin case.)

Memo

If you use threads other than those listed above, the embroidery may not sew out correctly.

Note

• Do not leave objects in the range of motion of the embroidery frame. The frame may strike the object

and cause a poor finish to the embroidery pattern.

• When embroidering on large garments (especially jackets or other heavy fabrics), do not let the fabric

hang over the table. Otherwise, the embroidery unit cannot move freely, and the pattern may not turn

out as planned.

■ Embroidery Needle Plate Cover

Under some conditions, based on the type of fabric,

stabilizer, or thread being used, there may be some

looping in the upper thread. In this case, attach the

included embroidery needle plate cover to the

needle plate. Attach the cover by inserting the two

projections on the underside of the cover into the

notches on the needle plate as shown below.

a Groove

b Projection

c Notch

To remove the embroidery needle plate cover, place

your fingernail in the groove and lift the plate out.