Removing The Embroidery Unit - Baby Lock Ellegante2 BLG2-NZ Instruction And Reference Manual

c
Insert the embroidery unit connection into
the machine connection port. Push lightly
until the unit clicks into place.
a Embroidery unit connection
b Machine connection port
c Feed dog position switch
Note
• Be sure there is no gap between the
embroidery unit and the sewing machine. If
there is a gap, the embroidery patterns will
not embroider with the correct registration.
• Do not push on the carriage when installing
the embroidery unit onto the machine.
Moving the carriage may damage the
embroidery unit.
• Be sure to set the feed dog position switch
to right to lower the feed dogs.
d
Turn the main power to ON.
→ The following message will appear.
e
Press .
→ The carriage will move to the initialization position.
b
a
c

■ Removing the Embroidery Unit

a
b
BEFORE EMBROIDERING
Note
• A confirmation message to lower the frame-
securing lever after the carriage moves to its
initial position.
• The message will disappear after
15 seconds or press
the next step.
Press either or
.
→ The carriage will move to the removal position.
CAUTION
• Always remove the embroidery frame before
pressing . Otherwise, the frame may
strike the embroidery foot, and possibly cause
injury.
• The embroidery unit will not fit in the storage
case if this step is not done.
Turn the main power to OFF.
Note
• Be sure to turn off the machine before
attaching the embroidery unit, otherwise
damage to the machine may result.
to move to
, then press
5
147