Starting A Smash Clp Session - Avocent MERGEPOINT SP MANAGER Installer/User Manual

Targets
/admin1/map1/ipendpt1
/admin1/map1/nodemanagesvc1
/admin1/map1/oemavocent_
discoverysap1
/admin1/map1/sshsvc1
/admin1/map1/swid[n]
/admin1/map1/telnetsvc1
/admin1/system[n]
/admin1/system[n]/fan[n]
/admin1/system[n]/log1/record[n]
/admin1/system[n]/sensor[n]
/admin1/system1/textredirectsap[n]
Starting a SMASH CLP session
To start a SMASH CLP session, start an SSH session and then enter the
To start a SMASH CLP session:
1. Start an SSH session. See Using SSH with the MergePoint SP Manager on page 104.
Chapter 8: Using SMASH Command Line Protocol
Description
IP address of MergePoint SP manager. For an example procedure using this
target, see MergePoint SP appliance commands on page 157.
The servers on the side navigation bar. For an example procedure using this
target, see To add a server to the side navigation bar: on page 160.
The automatic discovery service access points (IP address range for the IP
addresses of the service processors). For an example procedure using this
target, see To configure automatic discovery: on page 159.
The SSH service on the appliance. For an example procedure using this
target, see MergePoint SP appliance commands on page 157.
To upgrade the appliance and roll back to the previous version. For an
example procedure using this target, see To upgrade MergePoint SP
manager firmware: on page 162 and see To roll back the firmware to a defined
version: on page 162.
The Telnet service on the appliance. For an example procedure using this
target, see MergePoint SP appliance commands on page 157.
The managed servers. For an example procedure using this target, see To
reset a managed server: on page 165.
A managed server's hardware fans. For an example procedure using this
target, see To check fan data on an managed server: on page 166.
A managed server's event log records. For an example procedure using this
target, see To manage system event logs on a managed server: on page 168.
A managed server's hardware sensors. For an example procedure using this
target, see To check sensor data on an managed server: on page 165.
The console redirection service. For an example procedure using this target,
see To start a console redirection to an service processor: on page 166.
155
command.
clp