Table of Contents
Advertisement
MergePoint® SP Manager Installer/User Guide
112
If you are logged into the console as the root user, enter the
root@MergePoint:~# restoreconf [path]/<filename>
NOTE: The path of the file must be the same path the saveconf command defined. Otherwise, the system attempts
to get the file from the /storage directory.
Restoring factory default configuration files
A root user can restore the factory default configuration files from a specific file by performing
the following procedure while logged in through the console, Telnet or SSH to restore the
configuration files to the state they were in when the MergePoint SP manager shipped.
To restore the factory default configuration files from the command line:
Log into the console as the root user and enter the
root@MergePoint:~# restorefactory
Shutting down the MergePoint SP Manager
MergePoint SP manager administrators can shut down the appliance at any time through either
the web interface or the command line.
CAUTION: Clicking the Shutdown button or entering a shutdown command immediately stops all active services
and sessions.
To shut down the MergePoint SP manager:
1. If you are logged into the web interface as an administrative user, select System - Setting
and click Shutdown.
-or-
If you are logged into the console as the root user, enter the following command to
shut down the appliance:
root@MergePoint:~# halt
-or-
root@MergePoint:~# power off
2. (Optional) Wait one minute, or until you see the shutdown message in the console
interface or hear a beeping noise, then unplug the appliance.
Configuring Groups for Use with Authentication Servers
This section applies when an authentication method that relies on an authentication server is
configured for the MergePoint SP manager. If the administrator of an authentication server
restoreconf
command:
restorefactory
command:
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
