Native Ip Operations Using Ssh Commands - Avocent MERGEPOINT SP MANAGER Installer/User Manual

MergePoint® SP Manager Installer/User Guide
92
To add a route or set the appliance as a default gateway at the user's workstation:
NOTE: This procedure is provided for your convenience, but specific steps may vary depending on the host
operating system. For more information, see the installer/user guide for the host operating system.
Open the Internet Protocol (TCP/IP) Properties window and enter the MergePoint SP manager IP
address in the default gateway field.
-or-
Add a route by entering the appropriate command for your operating system; for example:
C:\Documents and Settings\admin>route add 192.168.1.20 mask
255.255.255.255 172.26.26.23
To directly connect to a native interface on a service processor:
NOTE: Before accessing the native interface, make sure you have already added a route or set the appliance as
the default gateway for the host.
1. In the side navigation bar, click an SP name.
2. Click the Configuration tab.
3. In the top navigation bar, click Native IP, then click Go to native IP interface.
NOTE: The Go to native IP interface option is not visible if Native IP is not enabled.

Native IP operations using SSH Commands

Admin users can create Native IP trusts and open Native IP connections with SSH commands.
Admin users can specify what IP addresses from which interfaces are trusted to bring up direct
connection to service processors.
To login to the MergePoint SP manager console as admin user:
You may log in to the MergePoint SP manager with any of the SSH clients, such as PuTTY
tool, SecureCRT tool or OpenSSH client. The following command examples use the OpenSSH
client under a Linux terminal.
Run the command by entering the following:
admin@MergePoint:~$ ssh -t username@MergePoint_IP_or_DNS_name
For example:
admin@MergePoint:~$ ssh -t admin@172.26.25.173
To enable selective mode:
Run the command by entering the following:
admin@MergePoint:~$ nativeipctl truston 0.0.0.0/0.0.0.0