Avaya

EC500 User Manual page 49

Enabling/disabling an individual EC500 extension
Some non-standard setup users, however, may want to enable or disable only a
single extension (for example, disable call waiting only by entering the extension
number representing their second incoming line or enable their home office
EC500 extension while working at home, but not their cell phone).
The following procedure describes how to enable or disable a single EC500
extension.
NOTE:
When administered to send office caller ID, this feature remains operational
regardless of whether EC500 is enabled or disabled.
To perform this procedure, you need the individual extension number(s) of the
phone(s) to be enabled/disabled, and the associated station security code(s).
NOTE:
You should have the EC500 access number and EC500 feature access
codes recorded on your pocket reference card.
Perform this procedure from any touch-tone phone.
1. Dial the EC500 access number.
If you are enabling or disabling EC500 using a phone that is part of your
office telephone system, skip this step and begin with Step 2.
You hear a dial tone.
2. Enter the appropriate EC500 feature access code ("enable" or "disable").
You hear a dial tone.
3. Enter the EC500 extension number assigned to the phone you want to
enable/disable.
4. Press # on your telephone keypad.
5. Enter the station security code of the EC500 extension being
enabled/disabled.
6. Press # on your telephone keypad.
You hear a confirmation tone indicating EC500 is enabled/disabled,
depending on the feature access code you entered in Step 2.
7. Hang up to end the call.
Repeat this procedure for each EC500 extension you wish to enable/disable.
49
Issue 4 May 2003