Advertisement
System 10
Digital Wireless System
Installation and Operation
ATW-1101
UniPak
Transmitter System
®
ATW-1101/G
Guitar System
ATW-1101/H
Headworn Microphone System
ATW-1101/H92
Miniature Headworn Microphone System
ATW-1101/H92-TH
Miniature (beige) Headworn Microphone System
ATW-1101/L
Lavalier Microphone System
ATW-1102
Handheld Microphone System
Advertisement
Table of Contents
Related Manuals for Audio Technica System 10
Summary of Contents for Audio Technica System 10
- Page 1 System 10 Digital Wireless System Installation and Operation ATW-1101 UniPak Transmitter System ® ATW-1101/G Guitar System ATW-1101/H Headworn Microphone System ATW-1101/H92 Miniature Headworn Microphone System ATW-1101/H92-TH Miniature (beige) Headworn Microphone System ATW-1101/L Lavalier Microphone System ATW-1102 Handheld Microphone System...
- Page 2 Featuring stackable, contemporary harmful interference to radio communications. However, there is no styling, System 10 is available in handheld, headworn, guitar, lavalier guarantee that interference will not occur in a particular installation. If and body-pack configurations. Operating in the 2.4 GHz range, far from...
-
Page 3: Receiver Installation
— both for safety, and to conserve energy.) sources such as other digital equipment, microwave ovens, as well as away from large metal objects. Keep System 10 receiver 30' (9 m) Antennas away from wireless access points. In multi-channel systems, position Rotate the permanently attached antennas in the shape of a “V”... - Page 4 System 10 Installation and Operation ATW-T1002 Transmitter Setup Controls and Functions Battery Selection and Installation Two alkaline AA batteries are recommended. When inserting the battery, observe correct polarity as marked inside the battery compartment. Power / Battery / Mute Status Indicator...
- Page 5 System 10 Installation and Operation Microphone / Instrument Level Control Pairing Switch Screwdriver System ID Display Battery Compartment Figure D — ATW-T1001 UniPak Transmitter ® UniPak ® Transmitter Battery Installation 1. Slide off the battery cover. 2. Carefully insert two fresh AA alkaline batteries, observing polarity markings.
-
Page 6: System Operation
Due to the dynamic nature of System 10 automatic frequency selection, the actual The transmitter’s Power / Battery / Mute status indicator glows red transmitting frequencies may change during power-up or performance. -
Page 7: System Frequencies
3. The transmitter and the receiver should be as close together as con veniently possible, but not less than 6' (2 m). System Operating Frequencies 4. While System 10 has been designed to stack for convenient multiple-system operation, please keep other wireless devices Automatic Frequency Selection... -
Page 8: Specifications
System 10 Installation and Operation Specifications OvERALL SySTEm UnIPAk TRAnSmITTER ® Operating Frequencies 2.4 GHz ISM band RF Output Power 10 mW Dynamic Range >109 dB (A-weighted), typical Spurious Emissions Following federal and national regulations Total Harmonic Distortion <0.05% typical...