Honeywell VisionPRO 8000 Product Data page 32

TM
VisionPRO 8000 Touchscreen Programmable Thermostat
PROPORTIONAL COOL
CONTROL POINT
P+I CONTROL
POINT
PROPORTIONAL HEAT
CONTROL POINT
THERMOSTAT
HEAT SETPOINT
HEATING
100 50
PERCENT LOAD
Fig. 31. Proportional temperature control versus P+ I
temperature control.
Minimum Off-Timer
The Thermostat has built-in compressor protection (minimum-
off timer) that prevents the compressor from restarting too
early after a shutdown.
The minimum-off timer is activated after the compressor turns
off.
If there is a call during the minimum-off timer, the thermostat
shows "Wait" in the display.
TUE
FAN
Inside
AUTO
SYSTEM
HEAT
COOL
SCHED
When the minimum-off timer expires, "Cool On" or "Heat On"
appears solidly in the display and the compressor and fan turn
on.
_________
a
Heat Pumps only.
68-0280—01
THERMOSTAT
COOL SETPOINT
P+I CONTROL POINT
COOLING
0 50 100
M4414
WED
Set To
WaitCool
Following
Schedule
AM
PM
HOLD CLOCK SCREEN MORE
M22244
Inside Humidity Level
Select models can sense the humidity level in the home. The
humidity level in the home is shown in the lower right corner of
the Home Screen.
TUE
FAN
Inside
AUTO
SYSTEM
HEAT
SCHED
If thermostat is set to Auto Changeover System mode, press
the More key until the humidity level is shown on the screen.
MON TUE
Inside
SCHED SCHED
DONE
a
32
Set To
Following
Schedule
PM
Humidity
HOLD CLOCK SCREEN MORE
M19966
WED THU FRI SAT SUN
HOLD HOLD CLOCK SCREEN
WAKE LEAVE RETURN SLEEP CANCEL
M22452