Honeywell VisionPRO 8000 Installer Setup And System Test Pocket Manual

Table 1. Installer Setup
Setup functions Setting & Options (factory
default in bold)
0520 U/V lamp change 0 Off
reminder 1 365 calendar days
0530 Adaptive Intel- 1 On
ligent Recovery 0 Off
TM
0540 Program periods 4 4 periods (Wake,
Leave, Return, Sleep)
2 2 periods (Wake, Sleep)
0580 Compressor 5 5-minute compressor
protection off time
[Other options: 0–4
minutes]
0600 Heat temperature 90 Max. heat temperature
range stop setting is 90°F (32°C)
[Other options: 40-89°F
(4°C to 32°C)]
0610 Cool temperature 50 Min. cool temperature
range stop setting is 50°F (10°C)
[Other options: 51-99°F
(11°C to 37°C)]
0640 Clock format 12 12-hour time
24 24-hour time
0650 Extended fan 0 Off
timer (heat) 90 Fan runs for 90 seconds
after call for heat ends
0660 Extended fan 0 Off
timer (cool) 90 Fan runs for 90 seconds
after call for cooling ends
0670 Keypad Lockout 0 Unlocked
1 Partially locked
2 Fully locked
6
Table 1. Installer Setup
Setup functions Setting & Options (factory
default in bold)
0680 Heat temperature 2 Standard temperature
control control (recommended)
1 Select if inside tempera-
ture is consistently over
setting
3 Select if inside tempera-
ture is consistently under
setting
0690 Cool temperature 2 Standard temperature
control control (recommended)
1 Select if inside tempera-
ture is consistently over
setting
3 Select if inside tempera-
ture is consistently under
setting
0700 Temperature 0 No offset
display offset [Other options: -3, -2,
-1, 1, 2, 3°F (-1.5°C to
1.5°C)]
0710 RESET 0 No reset
1 Reset installer options
& program schedule to
factory default
7
InsTalleR sysTem TesT
The Installer Test is part of the Installer Setup Menu.
1. Enter the Installer System Test by entering the Installer
Setup and pressing t repeatedly until "Test" appears.
DONE
M24083
2. Use arrow to change test and system status as
required.
TEST NUMBER
SYSTEM STATUS
DONE
M24085
3. Press DONE to exit.
8
sysTem TesTs
Test the system's heating, cooling, fan and emergency heat.
Available tests vary by thermostat and system type.
Table 2. Installer System Test
System Test Test Type System Status Number
Number and Description
Test 1 Cooling System 0 Off
Test 1 Compressor and
fan on
2 Second stage
compressor on
Test 2 Fan System 0 Off
Test 1 Fan on
Test 3 Heating System 0 Off
Test 1 Heat on
2 Second stage heat
(Aux. heat) on
3 Third stage heat
(Auxiliary heat) on
Test 4 Emergency 0 Off
Heat Test 1 Em. Heat and fan on
2 Auxiliary heat on
Press the DONE button to exit the Installer System Test.
caution
EQUIPMENT DAMAGE HAZARD.
Compressor protection is bypassed during testing. To
prevent equipment damage, avoid cycling the compres-
sor quickly.
9
VisionPRO 8000
®
Thermostats
InsTalleR seTuP and
sysTem TesT POckeT GuIde
InsTalleR seTuP
1. Press SYSTEM.
FAN
Inside
ON
AUTO
SYSTEM
HEAT
AM
SCHED HOLD
M24079
69-1871-1