Mechanical Installation - EAW CF-2LZ Installation Manual

CF-2LZ and CF-2TX Mechanical Installation
Mounting the clip-fit brackets to the wall:
a. Mount the wall bracket to the desired
surface, in this vertical orientation
only. Note that the bracket has two
mounting keyholes with vertical
spacing that allows them to be used
with a standard wall J-box.
Two screws are supplied for securing
the wall bracket to a J-box. Install the
shorter 6-32 screw in the top hole of
the J-box, and the longer screw in the
bottom. Only screw them in by a few
threads initially, then place the clip-fit
bracket over the screws through
the key-hole slots in the bracket as
shown. Tighten the screws once the
bracket is securely in place.
b. In addition to securing the bracket to a J-box, secure it to a structural wall stud with
user-supplied hardware. The spacing of the four corner holes is designed to align
with structural studs on either side of the single-position J-box.
Rotating the loudspeaker's input section (if required):
The loudspeaker can be mounted vertically (as shown here)
onto the clip-fit bracket, or horizontally. If you want to change
the orientation, follow these steps:
a. Remove the four screws holding the circular input section
in place.
b. Pull out the input section by approximately half
an inch, and rotate it through no more than 90
degrees.
c. Secure the input section into its new position with the
four screws.
9
CF-2LZ/CF-2TX–