Cf-2Lz Electrical Installation - EAW CF-2LZ Installation Manual

CF-2LZ Electrical Installation

Note: Observe all local and national codes when installing the CF-2LZ clip-fit bracket.
All connections to the loudspeaker must be made with the power amplifier turned off.
Two wire crimps are included to make the connections.
The following example of a low-impedance connection uses a EAW Commercial CAZ800
amplifier. This amplifier uses a screw-terminal output.
INPUT
CONNECTION
B
B (+)
B (--)
LINE
(BALANCED)
GND AMP MODE
INPUT
A (--) A
A (+)
LINE
(BALANCED)
1. Connect the A + terminal on the amplifier to the red (+) input wire on the CF-2LZ.
CAZ800-AMPLIFIER
2. Connect the A – terminal on the amplifier to the black (–) input wire on the CF-2LZ.
CHANNEL B BRIDGED CHANNEL A
B (+) B (-) (+)
The loudspeakers have a nominal impedance of 8 ohm. If you connect other
loudspeakers in parallel, make sure that the overall impedance does not drop below
the minimum required by your power amplifier.
8
– CF-2LZ/CF-2TX
INPUT
CAZ800-AMPLIFIER
CHANNEL B BRIDGED CHANNEL A
MONO
B (+) B (-)
STEREO
(-) A (+) A (-)
CAUTION
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS APPARATUS TO RAIN OR
MOISTURE. SEE INSTRUCTIONS BEFORE USING.
BREAKER SERIAL / DATE CODE
(+) (-) A (+) A (-)
CAUTION
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS APPARATUS TO RAIN OR
MOISTURE. SEE INSTRUCTIONS BEFORE USING.
SERIAL / DATE CODE
BREAKER